Cookiename	Beispielinhalt	Ablaufzeit
_ga_*	deleted	730 Tage
_ga	GA1.1.8643343795.1726666186	730 Tage

Variator sleeve for Barossa Skywalker 250R

Variator sleeve for Barossa Skywalker 250R

SKU: NK70003-BarossaSkywalker250R
GTIN: 4057711791273
Category: Engine / technics
Manufacturers: Götz

26,70 €

incl. 19% VAT , plus

Manufacturers recommended retail price: 39,95 €

(Save 33.17%, i.e. 13,25 €)

Currently out of stock
Delivery status: 1-4 days

Variator sleeve for Barossa Skywalker 250R Vario sleeve Tuning Quad ATV

The tuning variator sleeve for Barossa is the simplest and most effective method for more performance gain.

The variator is like the transmission at switching vehicles at the heart of the drive of an automatic Quad and ATV.

Modified variator sleeve with adapted thrust washer for Barossa Skywalker 250R all models and variants corresponding.

The length of the sleeve and the disc is original vario the belt further pushed into a position outward.
This causes an increase in the terminal velocity of 5 to 15 km / h. The optimal acceleration results is guaranteed with 20g variator rollers (not included!).
See variator rollers in our shop.

In conection with the Malossi variator Multivar the very good acceleration values of the variator can connect with the significant speed increase Vario sleeve.
This results in the best possible tuning variant for driving range.

The Vario sleeve fits in exchange for the original Vario sleeve or in exchange for the Vario sleeve Malossi Multivar.

Attention!
Please note for mounting the installation instructions.

Installation instructions of the Vario sleeve:

Installation instructions / Mounting instructions Variomatikhülse

The variator sleeve is simply replaced with the original part.
Given the vario case is dismantled and dissolved the central nut on the crankshaft.
The shim is removed.

Thereafter, the outer pulley is deducted from the tail shaft.
The sleeve is now open.
Now hold on with one hand, the variator and remove the sleeve.
Then the Vario sleeve instead of the original sleeve refit.
The pulley touched down again.
Pay attention to the teeth.

Next, the central nut onto the crankshaft and tighten.
.
For the shim is not mounted.
For this reason, the installation of the supplied shim falls away easily.
Additionally, however, the supplied washer is assembled as follows:
After the outer pulley was set up, the starter gear is placed.
the supplied galvanized washer with the dimensions 30x17x3 Next on the
Tail shaft pushed.
Replace and tighten Now the central nut.
Make sure that the washer is centered.
The washer is used to ensure the necessary distance to the threaded end of the crankshaft.
The tightening torques of the parent amounted to 90-100 Nm.
The Vario sleeve fits in exchange for the original Vario sleeve or replace
against the Vario sleeve Malossi Multivar.
In conjunction with the Malossi variator Multivar can the very good acceleration values
the variator with the boosts speed of the sleeve connecting.
This results in the best possible tuning variant for driving range.