Tuning
Variator sleeve for Kymco KXR Maxxer MXU Mongoose 250/300 Vario sleeve Tuning Quad ATV
The tuning variator sleeve for Kymco is the simplest and most effective method for more performance gain.
The variator as the transmission at switching vehicles at the heart of the drive of an automatic Quad and ATV.
Modified variator sleeve with adapted thrust washer for Kymco KXR Maxxer MXU Mongoose 250/300 all models and variants corresponding.
The length of the sleeve and the disc is original vario the belt further pushed into a position outward.The optimal acceleration results with 20g variator rollers causes (not included!).
See variator rollers in our shop. In conjunction with the Malossi variator Multivar can the very good acceleration values of the variator with the significant speed increase Vario sleeve connect.
This results in the best possible tuning variant for driving range. The Vario sleeve fits in exchange for the original Vario sleeve or in exchange for the Vario sleeve Malossi Multivar. Attention!
Please note for mounting the installation instructions.
There is a difference between KXR / MAXXER / Mongoose and MXU models.
Installation instructions of the Vario sleeve:
Installation instructions / Mounting instructions Variomatikhülse KXR / MXU / MAXXER
The variator sleeve is simply replaced with the original part.
Given the vario case is dismantled and dissolved the central nut on the crankshaft.
The shim is removed.
[At MXU models, the starter gear removed for pullstarter]
Thereafter, the outer pulley is deducted from the tail shaft.
The sleeve is now open.
Now hold on with one hand, the variator and remove the sleeve.
Then the Vario sleeve instead of the original sleeve refit.
The pulley touched down again.
Pay attention to the teeth.
Now comes the difference between KXR / MAXXER and the MXU models.
In KXR and MAXXER models the supplied shim instead of KYMCO is
Shim mounted.
Next, the central nut onto the crankshaft and tighten.
The MXU models feature the starter ring gear for the pull starter as in the
Drawing ready.
For the shim is not mounted.
For this reason, the installation of the supplied shim falls away easily.
Additionally, however, the supplied washer is assembled as follows:
After the outer pulley was set up, the starter gear is placed.
the supplied galvanized washer with the dimensions 30x17x3 Next on the
Tail shaft pushed.
Replace and tighten Now the central nut.
Make sure that the washer is centered.
The washer is used to ensure the necessary distance to the threaded end of the crankshaft.
The tightening torques of the parent amounted to 90-100 Nm.
The Vario sleeve fits in exchange for the original Vario sleeve or replace
against the Vario sleeve Malossi Multivar.
In conjunction with the Malossi variator Multivar can the very good acceleration values
the variator with the boosts speed of the sleeve connecting.
This results in the best possible tuning variant for driving range.
Manufacturer: | motorsportgoetz |
Category: | CVT clutch |
SKU: | NK70003 |
GTIN: | 4250362411044 |
Displacement: | 250300 |
Brand: | Kymco |
Type of vehicle: | Quad ATV UTV |
Model: | MXUKXRMaxxerMongoose |
Tuning: | More power, higher top speed |
0
Others also bought:
Similar items