Tool for nut for rear clutch female with thread M28x1 with key width 39m for example for Aprilia, Minarelli, Piaggio, Peugeot, Kymco scooter
Tool for clutch nut with M28x1 for the clutch (central nut under the clutch bell).
Fits all Minarelli, Aprilia with Minarelli engine, Kymco, Peugeot, Honda engines and many others.
Key width of the coupling nut is 39mm.
Tool for removing the clutch bell (holding tool) and loosen the large nut under the clutch bell.
This tool is required to perform work on the clutch, the rear transducer and the backpressure spring.
Key range: 39mm
Diameter of each pin: 11,2mm
Distance between the pins: 60mm
Used with Honda, Peugeot, Kymco, SYM and most Minarelli and China engines 50cc and 125 / 150cc.
If you are not sure, the necessary key width must be measured before ordering on the nut of the coupling.