ECU CDI PowerJet Controller BMW F 800 GS/ST/R/S

159,95 €
including 19% VAT. , plus shipping
Recommended retail price: 195,00 €
(You save 17.97%, that is 35,05 €)
ECU CDI PowerJet Controller BMW F 800 GS/ST/R/S

For this product you will receive 319.9 Reward Points

Set

Notify me when this product is available

10 ordered, expected on 16.08.2022

Delivery status: 1-4 days


PowerJet Controller BMW F 800 GS/ST/R/S motorcycle

Most fuel injected engines run very lean and this is fine except for when demanding maximum power output on the track, especially when you have sport exhausts installed.
Being able to simply adjust by yours BMW F800 GS/ST/R/S the fuel/air ratio in those conditions would be wonderful wouldn't it?

The PowerJet Fuel Controller allows just that on yours BMW F800 GS/ST/R/S!

You can adjust the fuel map from -4% to +10% by selecting one of the 10 settings.

We even incorporated a stock setting which means no change compared to stock.

Our PowerJet controller is a simple yet complicated device.
It measures the outside air temperature very close to where the stock sensor is located, and adjusts the signal from the OEM air temperature sensor to the ECU to make use of the built in Air Temperature Correction factor that is built into every stock ECU.

What this accomplishes is that the ECU is told that the intake air is a little cooler than it is, and the ECU will respond by injecting a fraction more fuel depending on the PowerJet setting.

You as a rider will notice a substantially improved engine response when you twist the throttle by yours BMW F800 GS/ST/R/S.

The neat thing is that when under constant load (constant speed) the oxygen sensor in the exhaust will make the ECU correct the fuel/air ratio back to stock!
However, as soon as the system notices an increase in power it switches from closed loop (oxygen sensor feedback) back to open loop (no feedback) and will correct the fuel/air ratio by the amount you selected on the PowerJet.

PowerJet Controller can be easily installed by plugging it in between the stock AIT sensor which is usually located somewhere on the airbox and the bike's wiring harness.
Each PowerJet comes with the exact plug in connectors and installation will normally only take a few minutes.
Finding the air temperature sensor usually takes more time than plugging in the PowerJet.

You can leave the PowerJet sitting under the bodywork somewhere as it is designed to be rugged and waterproof. After figuring out what setting works best with your specific engine/exhaust/intake combination you typically do not need to adjust it any more.

PowerJet comes with a full two year warranty.
Scope of delivery: PowerJet Controller complete with wiring harness.
Ready to install withouth any changings on yours BMW F800 follow models:

BMW F800ST 2007
BMW F800ST 2008
BMW F800ST 2009
BMW F800ST 2010
BMW F800ST 2011
BMW F800ST 2012
BMW F800GS 2009
BMW F800GS 2010
BMW F800GS 2011
BMW F800GS 2012
BMW F800R 2011
BMW F800S 2007
 

Manufacturer:
Category: CDI / ECU Tuning
Item number: BMW-PJ
Brand‍: BMW
Type of vehicle‍: Motorcycle
Tuning‍: More power, higher top speed

0

Write your first review and help others with their purchase decision:

Contact
Question on item


Please login first to add a tag.