The award-winning of Swisher ATV QuickSwitch System is designed to allow you to quickly change between a wide variety of front and rear heavy-duty attachments.

Swisher’s unique, patent-pending QuickSwitch Mount Kits attach to the underside of virtually any ATV (see Fit Criteria below) and run the full length of your ATV for unparallelled strength and stability.
Unique leaf spring design takes the weight off the front suspension, providing unmatched maneuverability while carrying heavy loads*
Easy, user-friendly installation can be done in minutes
Quickly connect and disconnect various attachments by pulling a single pin, no tools required
Connect to a front or rear winch by simply attaching a cable

Use in conjunction with Swisher front attachments
(Dump Bucket, Plow Blade) and rear attachments (Box Scraper, Disc Harrow, or Grader Blade).

Heavy-duty steel construction for longer life
Protected by a powder coat finish for long-lasting durability
For a complete QuickSwitch System, choose one or all of the Swisher ATV front and rear attachments – Dump Bucket, Plow Blade, Box Scraper, Disc Harrow or Grader Blade.

Next, select the appropriate mounting kit. For front attachments, choose the QuickSwitch Front Mount Kit (part No. 2646). For rear attachments, purchase the QuickSwitch Rear Mount Kit ( part No. 6461) as an add on to the existing Front Mount Kit.

Finally, determine the lifting mechanism.
All QuickSwitch front and rear attachments may be used in conjunction with winches (sold separately).
A front winch can be used to lift and lower both the front attachments and the rear attachments.
A separate winch for the rear attachments is not necessary but can be added easily for additional versatility.
The plow blade can be lifted with a manual lift or a winch (each sold separately).

Fit Criteria for Swisher QuickSwitch System:

Independent front suspension with lower A-arms
ATV must have a rear tow hitch bracket
Distance from the center of the hole in the tow hitch bracket to the front of the front tires must be at least 61" but not more than 73". (If the measurement is greater than 73" you will need our part number 2900 Extension Kit. This will extend the unit up to 26 1/2").
Minimum length of the assembled accessory mount from the hitch bracket to the mounting holes in the yoke at the front of the mount is 63", maximum length is 75" (unless part number 2900 Extension Kit is utilized). Mounting holes in yoke should be 2" in front of front tires when properly installed.
Maximum distance between the leaf spring brackets (mounted to the front A-arms) is 32" assuming 4" of spring overlap at center of bike between Spring Mounting Plates. If the springs contact the opposite side bracket, they can be cut to fit.
Minimum recommended ATV size is 300 cc
Minimum ground clearance recommended is 9"