Battery 12V 20Ah Y50-N18L-A C50-N18L-A starterbattery

Battery Y50-N18L-A2 / C50-N18L-A2 maintenance-free -include acid-package

very high quality with better results by starting the engine and for long lifetime!-reduce self-discharging of battery to the lowest level and grants longer life span

dimensiones 205 x 90 x 162 mm
volt 12
Ampere 20

-totally leakage prevented and free of corrosive trouble
-safer for user, environment and motorbike
-easy to install like the original battery

To consider when you make the battery ready:
The batteries are supplied dry, fill it with the included battery acid to activate it.
No acid or other similar use to fill!
After remaining free up the battery with the supplied specially suitable battery acid (never use something else) to rest the battery.
After about 30 minutes (at best then when the battery forms no more bubbles) once fully charged.
Then just close the shutter bar.
Do NOT open the battery anymore!
Check the acid level is usually not necessary because the self-discharge is less than standard batteries.
During prolonged periods of "non-use", such as when the winter is often the case, remove the battery and take of on-board voltage.
Then store in a cool dry place and regularly charge on battery charger.

The battery is an aggregation of multiple galvanic cells.
Each of the cells includes a plurality of lead grids.
These are alternated with lead oxide, this is the positive / positive pole of the battery, and very porous lead, which is the negative / minus pole coated.
The separator consists a porouse insulating material. The separator prevents the plates touching eachother, which would cause a short circuit.
The battery is charged in a dry state.
If now the electrolyte, that dilute sulfuric acid is poured into the battery, the discharge starts.
During the discharging, electrons move from the negative to the positive pole. Arise here about 2Volt per cell (1.75 to 2.4 V) power.
In series by connecting in series so for example of three cells you have a 6 volt battery, six cells by a 12 volt battery.
The series connection of the battery is totally defective should just one cell be damaged!

Each battery has a certain amount of wear which can not be prevented.
For example, it is so that the lead plates corrode over time and lose material.
It may contain impurities and dirt deposits that can progress to a highly flammable explosive gas.
Over time, the sulfur material as sulfated batteries the electrolyte is combined with the lead plates and the crystals formed which inhibit the flow of electrons.
The batteries is added to a Antisulfat. This significantly slows down these processes and thus has a much longer battery life!
The disadvantage of this is that in the dry state, the battery can not be charged greatly.
Therefore, for a long battery life needed after filling and the rest this necessarily fully charge!